1. When the charging stand charges the VR helmet and two handles at the same time, in order to provide sufficient current, the charging stand must be equipped with a charger with an output of more than 5V2A. 2. The original charger provided in the 0culusQuest2 package can be used for this charging standSteps to charge the helmet 1. Connect the charger with more than 5V2A to the charging seat (the charger is not included in this package, the customer needs to purchase it separately). The charging seat turns on the green light and enters the power-on standby state2. Insert the Type-c magnetic head into the charging hole of the helmet. 3. Put the helmet vertically into the corresponding charging position of the charging base. When charging starts, The charging LED indicator lights up yellowAt the beginning, the LED indicator of the cradle will light up yellow (please note that the handle is divided into left and right, please place the handle according to the "L" and "R" marks on the cradle) If you want to take out the magnetic head of the handle, please use the needle provided in the package to pick out the magnetic headSpecification: Battery type: Lithium polymer battery. Battery capacity: 1800mAh. Grip battery life: about 36 hours. Charger output needs: 5VGreater than 2A. Charging current: Helmet: Max 1.4A Handle: Max 500mACharging time: helmet: about 3.5 hours handle: about 2.5 hoursDock charge indicatorStandby mode: green lightCharging: Yellow lightFull: green lightSpecifications:Need charger output: 5VGreater than 2ASteps to charge the handle1. Connect the charger with 5V2A or above to the charging seat (the charger is not included in this package, customers need to purchase it separately). The charging seat turns on the green light and enters the power-on standby state2. Slide the battery cover of the handle down and take out the battery cover3. Install the battery for the handle. When installing, please pay attention to the Type-C charging port of the battery as far as possible.4. Install the battery cover provided in this package on the handle5. Use the needle provided in this package to adjust the Type-C charging port of the battery to align with the hole of the battery cover6. Insert the magnetic head into the Type-C charging port of the battery through the hole of the battery cover7. Put the handle into the corresponding charging position of the charging base and let the magnetic suction head contact to charge.color: WhiteMaterial: ABSPackage Contents:1 x Charging base2 x battery2 x battery cover4 x USB Type C magnetic head1 x magnetic head removal needle1 x 1.2m charging cableOnly the above package content, other products are not included.Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.