Description

• M10-5883 uses multi-constellation GNSS powered by u-b lox MAX-M10S.

• MAX-M10S supports concurrent reception of four GNSS (GPS, GLONASS, Galileo, and BeiDou). The high number of visible satellites enables the receiver to select the best signals. This maximizes the position availability, in particular under challenging conditions such as in deep urban canyons. u-blox Super-S (Super-Signal) technology offers great RF sensitivity and can improve the dynamic position accuracy with small antennas or in non-line-of-sight scenarios. For maximum sensitivity in passive antenna designs, the MAX-M10S module integrates an LNA followed by an SAW filter in the RF path.

• More details about the MAX-M10S, pls check outu-b lox MAX-M10S page

Specifications

• USA (GPS), Russia(GLONASS), Europe (Galileo)

• Magnetic Compass QMC5883L

• Patch antenna 18*18*4mm

• Input voltage range: 4~9V (5V pad/pin)

• Power consumption: 13mA

• UART baudrate: 9600 default

• Operating Temperatures

• UART(TX, RX) interface for GNSS MAX-M10S

• I2C(DA, CL) interface for Compass QMC5883L

• JST-GH-6P connector (SM06B-GHS-TB)

• GNSS PPS LED, Green. (Solid ON after powering on M10-5883,  blinking(1Hz) when GNSS get 3D fix)

• 23mm*23mm*10mm

• 9g

Includes

• 1x M10-5883

• 1x JST-GH-6P to JST-GH-6P 20cm silicon wire

Wiring and settings

• M10-5883 5V to Flight controller 4~9V

• M10-5883 RX to Flight controller UART_TX

• M10-5883TX to Flight controller UART_RX

• M10-5883 CL to Flight controller I2C_SCL

• M10-5883 DA to Flight controller I2C_SDA

• M10-5883 G  to Flight controller GND

Tips and Notes

• Compass Alignment(Arrow forward and flat mounting): Tilting the magnetometer is strongly discouraged !INAV/BetaFLight: CW 270° Flip when flight controller arrow is facing forward also.Ardupilot/Mission Planner: Rotation None.

• Protocol: Ub lox 5Hz or NMEA 1Hz